If you desire to do the task right, get a borescope so you can look down the barrel and really see what's going on. Without a borescope, you're working blind.

 

Second, you have to get rid of copper fouling. Here is a list of what I utilize. J Dewey nylon-coated cleaning rods.

 

Take your patch rod, and put 3 solvent patches up the bore. When it does, follow with a dry spot.

 

The Only Guide for How To Clean An Ar-15 Or Modern Sporting Rifle - Liberty Safe

 

 

(Do not get J-B or oil or anything else on the lens of your scope. You will regret it.) If you see no copper, or simply a faint wash of copper occasionally, you're done. If you see gobs and gouts and swellings and streaks, it's back to the J-B.

 

If you do not have a borescope, run a solvent repair the bore and let it sit, muzzle slightly down, for a couple of hours. Run another solvent spot through, and if it comes out tidy, you're done, however if it has green or blue spots, back to the J-B.

 

As a rule, the more you invest on a barrel the smoother it will be and the less it will foul. Every barrel fouls to one degree or another. I have actually had one or two cases where a barrel unexpectedly began to group as I reached the end of the procedure, but I have actually had far more break-ins that made no distinction at all.

 

Getting My Basic Gun Maintenance: How To Clean A Rifle - Gunbroker.com To Work

 

They work, often, but if you forget and leave the things in your bore for more than 15 minutes, they will pit your bore but good, and considering that I'm at the age where I forget stuff, I hesitate to take the opportunity. Also, they're hell on stock finishes. With a bolt-action, go simple on the Break-Free.

 

Take a cue from the military, whose lives depend upon their firearms going bang. They want them immaculate. And immaculate is a great way to go.

 

The steps to appropriately clean your rifle depend on whether you are doing a field removing or complete disassembly. We'll cover fundamental field removing in this post. Due to the variety of rifles, total disassembly of the gun aren't within the scope of this post. This is the most crucial action in the entire cleaning procedure.

 

Little Known Questions About Gun Cleaning Clinic: So You Bought A New Rifle…what You ....

 

To get more information about this rifle, visit this link.

 

, and get rid of any loose particles that may be found within the action, bolt, receiver, frame and chamber.

 

One common misconception is that more is better when it comes to lubrication of your gun.

 

Soak a couple spots in this solvent and run them down the barrel. Allow it to sit, and keep in mind that getting rid of copper can take a while.

 

The Ultimate Guide To How To Clean A Gun In 5 Easy Steps In 2022 - Survival Cache

 

If the spot comes out stained blue, you still have copper in the barrel. Bill Buckley Keep In Mind: There's a lot of talk about how these copper solvents can damage your bore.

 

What you don't desire is to let any ammonia solvent dry in there. When you're satisfied that the copper is gone, run a couple of dry spots down the bore, followed by a couple of spots that have been damp with a regular cleansing solvent. Run 3 or four dry spots down the bore to remove any staying solvent.